Transducers for alternating voltage
• Class 0,5
• For mounting on DIN rail (DIN EN 50022-35)
• only 22,5mm width
• Load resistance up to 1000 Ohm @ 20mA
The transducers are to be applied for the measurement of alternating voltages (Nominal input voltages 100n to 690V).
For mounting on DIN rail (DIN EN 50 022).
The transducers are to be applied for the measurement of alternating voltages (Nominal input voltages 100 to 690 V). Please indicate the exact voltage on the order. For higher voltage transformers to be inserted before.
The input value is being galvanically insulated (5 kV / 1 min), rectified (averaging) and transformed into a proportional, graven direct current. The CUR doesn’t require any auxiliary supply. The type CUR/I is active (Output 4…20
mA) and requires some auxiliary supply of 230V AC or 24V DC
The small design of measuring converts with a width of only 22,5 mm is realized , as well, by a precise selection of components, as by a precise coordination of components and circuits, geared to power requirements and warming. The low power loss allows mounting of any quantity of transducers side by side, within the operating temperature range, without need to consider of minimum distances.